Thermador Dishwasher Error Codes

I need help with Thermador dishwasher error codes. The clean light comes on when it is running. However, given how often Thermador appliances break, that might seem like an error to you. I would know it was running if the dishes came out clean. Then you aren’t hearing the cycle done buzzer every fifteen minutes because it is waiting to be unloaded. The problem in that case would be lazy kids. And I can turn that feature off by holding down the light wash button while turning on the dishwasher. If someone paused the dishwasher due to noise, nothing is wrong, but you have to hit the on off button and close to door to get it to run. Or hit the new program button twice to change cycles. It is flashing lights and showing errors it doesn’t normally do. Do you have the sapphire glow function where it has a light that turns on when you open the door? No, I don't think so. Then the problem isn’t a broken door latch or door sensor on one of those dishwashers. I turn that function off with the buttons until it shows P02. I had to do that on our old dishwasher. If the check water supply light is on, you need to see if the water supply is blocked. How specifically do you do that? Make sure someone didn’t turn off the water because of a leak, verify you paid the water bill, that the supply hose isn’t kinked and the water filter in the water supply isn’t blocked. I’m glad I’ve never seen that error code. Most Thermador dishwasher codes are E01 to E30. That doesn’t tell me much more than the errors I see. E1 is an eeprom error, and it comes with light sequence code 22. That’s the error code for their ovens. If I saw something like that, the first thing I do to fix that is reboot the dishwasher, and if that doesn’t work, call for service. For any of their error codes, rebooting the dishwasher by turning it off at the breaker and back on is a possible solution if turning it on and off at the control board isn’t good enough. Anything short of a sledgehammer is possible given the cost of replacing a control board. E24 means the waste water hose in the dishwasher is blocked or kinked. That’s easy to figure out how to solve. Check the hose and unkink it if kinked, clean it if clogged. E25 means the waste water pump is blocked. Probably with more food residue. Or the cover has come loose and it isn’t in the position the unit thinks it should be in. What other lights or errors can I diagnose? If the rinse aid light is on, it wants rinse aid. I don’t use rinse aid. Then you can hold down the A button and hold start until it shows H00 and hit the A button until it says R05. Hit the C button until it says R00 to turn the dispenser off and save to save the setting change. If that was the problem I had, I wouldn’t have to worry about it. Then take it up with a service person to figure out what is wrong, if cleaning the dishwasher inside and out doesn’t fix this.