Proxxon Micromot MB 200 Drill Stand Unboxing, Detailed Review and Test

I want to drill nice straight holes, so I bought myself a drill stand … ↓↓↓ Complete description, time index and links below ↓↓↓ A while ago I acquired a Proxxon IBS/E professional drill/grinder: German “Industrie-BohrSchleifer” – hence IBS (link below). It’s basically a “Dremel” with less plastic. But I failed miserably at drilling holes into cheap, phenolic perfboards with it (links below). The holes were not exactly where I wanted them and the backside of the boards looked quite bad. A drill stand was required. I went with the more expensive Proxxon MB 200, ignoring their cheaper MB 140/S model. Because of the special 20mm necks of their tools it had to be a Proxxon (try to find a non-Dremel drill stand for a Dremel). And now I’ve made the perfect hole. However, otherwise that thing is a mixed customer experience. 00:00 Unboxing – or is it un-mail-bagging? 05:17 Assembling – a whole lot of lose screws 12:08 Examining – the ugly, the bad and the good 26:14 Mounting – the drill, it is a drill stand after all 28:25 Adjusting – the dovetail bearing (and calling it a “guide” ;-) ) 35:17 Testing – by drilling holes of course 44:11 Judging – the jury is still out Mailbag: Proxxon IBS/E – Unboxing, Runout Measurement and Test: https://youtu.be/LzeDN0omelc UV Exposure Unit Build (3): 1st UV LED Board Build and Test (Trial & Error): https://youtu.be/oekrRU5q0fI UV Exposure Unit Build (4): 2nd UV LED Board Build and Test (Near Perfection): https://youtu.be/k67puBpec28 Unboxings: https://www.youtube.com/playlist?list=PLwq-2MnM58FLpgXvAMIiwf7fiyoDuEpWh Mailbags: https://www.youtube.com/playlist?list=PLwq-2MnM58FL0P4F1o3NYB8MnralwhK3F