How to make Cascade Bouquet with fresh cut Roses and Gypsophilia (Baby's Breath) | GlobalRose

Cascade Bouquet visit http://globalrose.com/how-to-make-a-cascade-bouquet.html for Cascade Bouquet video. Find special offers on Gypsophila flowers at http://globalrose.com/flowers/gypsophilia Follow us on Google+ for for information, promotions and more! https://plus.google.com/b/116766743943818170153/116766743943818170153/posts What you will need : 8 Bridal Roses Gypsophilia (Baby's Breath) One Roll Of Green Floral Tape One Set Of Spears A Few Rubber Bands Two Or Three Decorative Pins One Roll Of Decorative Ribbon. Instructions: Choose a work area that includes a table or counter top and a floor that can resist water. On your table, have handy the following tools: In a water-filled container have ready your 8 rose stems and a handful of gypsophilia. One by one, remove all outside petals, lower leaves and thorns from each rose stem and place on table. Begin by placing one stem of gypsophilia on the table. On top of the gypsophilia, place two rose stems. As you place your flowers, stagger them so that the top layer does not block the bottom layer. On top of the roses, place two more stems of gypsophilia. Create a pyramid shape by widening the width of the bouquet and by placing three roses on top of the second layer of gypsophilia. On top of this layer, lay two additional stems of gypsophilia. Repeat step six until you have used all eight stems. With your hands, grab all eight rose and gypsophilia stems and adjust all the flowers so that they flow naturally. With the help of someone else, wrap a rubber ban tightly around the stems and below the leaves. Take the floral tape and, concealing the rubber band, wrap the tape around the stems until you reach the distance of approximately one inch from the bottom. With the same tape, continue wrapping upward until you reach the rubber band. At this point, you may cut the tape. Take the decorative ribbon you have chosen and wrap it around the stems, being sure to cover all the floral tape. When all the tape is covered, cut the ribbon and hold it in place by pinning it with a decorative pin. Add more pins depending on your taste. Take your spears and evenly trim the bottom of the stems. You did it! Enjoy.