DIY: 98-00 Ford Ranger Parking Light & Headlight Removal

Video tutorial on how to remove the headlights and parking lights on a Ford Ranger. You will be required to remove the parking/signal lights before removing the headlight and this tutorial does cover that. In this particular tutorial I am working on a 1998 Ford Ranger, but a similar procedure applies to other models as well. Website: http://4diyers.com Facebook: https://www.facebook.com/4diyers Google Plus: https://plus.google.com/+4DIYers Twitter: https://twitter.com/4DIYers Instagram: https://www.instagram.com/4diyers/ Tumblr: http://4diyers.tumblr.com Pintrest: https://www.pinterest.com/4diyers/ Time lapse headlight restoration: https://www.youtube.com/watch?v=HsGvJXp_vBI Parking light restoration using clear coat: https://www.youtube.com/watch?v=Rz7rAgEuAd8 Tools/Supplies Needed: -1/4" drive screwdriver handle -1/4" 1/4" drive socket -needle nose pliers -allen key or a small strong metal rod Procedure: -remove the parking and corner light assembly by removing the two 1/4” bolts located between the bumper and orange parking light -slide down the plastic cover to expose the parking/signal light bracket -then remove parking light assembly -disconnect the three light sockets by turning them counter clockwise and pulling them straight out -for the headlight, there are two clips in behind which we need to removed -if you have a pair of angled tip needle nose plier, they would make the removal the clips much easier -here I’ll be using a standard pair of needle nose pliers with an allen key in the end which will fit in the hole so I can disconnect each side of the clip -do this for each side of the clip -once done then pull upwards on the clip which will remove it -disconnect the last pivot point on the side of the headlight housing by using needle nose pliers and depressing the tangs -pull the clip straight out and you will be able to remove the headlight assembly -on the rear of the headlight assembly using a flat screwdriver, pop off the electrical connector that goes directly to the headlight bulb -installation in reverse Thank you to all those who watch my videos and support my content. Don't forget to subscribe to my channel for future tutorial videos and like my video if you found it helpful. New videos are always being uploaded every week! © 4DIYers 2013 All Rights Reserved No part of this video or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.