Common Problems With Making An Electric Go Kart or EBike and How I Resolved Them. #063

How I managed some design issues like center of gravity, speed vs torque and more. If you want to chip in a few bucks to support more content like this, please visit my patreon page. https://www.patreon.com/jeremyfieldingsr My website www.jeremyfielding.com Notes- Here are some electrical items I purchased for this project. I always encourage people to shop around, but if you use these links amazon gives me a small commission. 1. The clamp amp meter can measure very high DC and AC current without being connected to the circuit making is safer and easier to use. https://amzn.to/2KfuMks 2. Watt meter/Battery Monitor. I purchased the 500 amp version but I recommend you get the smallest one that will work for your application because you have to calibrate at 20% of the max capacity. https://amzn.to/2tzeFa3 RPM sensor. You could also get one that shows mph/kph after clicking the link... shop around and see what you like. https://amzn.to/2KgSBs6 Technical corrections I later found I could buy a 9 tooth sprocket for the 3/4" shaft, but by then the jack shaft and limited space made the difference insignificant.